Bullrings are the premium tie-down anchor point for your truck. While the stock anchors points are inside the bed where it’s hard to reach, Bullrings retractable anchor points easily install into the stake pockets on top of your bed rails. Each is made from stainless steel for a 1,000-lb capacity, matches the grain and color of Dodge & Toyota railcaps, and comes with a “no bull” Lifetime Warranty. Simply pop the stainless steel tie-down anchor ring up when you want to use it to secure a load, then hit it down flush when you don’t. Bull Ring’s tie-down anchors are an essential Toyota Tundra truck bed accessory.

This classic raised model sits just above the railcap, and requires a rail cap trim to be installed. Sold as a pair.

To get the most out of your tie-down anchors, they can be installed in the 4-6 stake pockets locations of your truck with 1, 2, or 3 pairs available to fit those slots.

• Installation:
  RAIL CAP TRIM:
• Newer model Dodge RAM and Toyota Tundra stake pockets are hidden underneath the plastic rail cap and require the rail caps to be trimmed before the anchor points can be properly installed. (See video for detailed instructions). We highly recommend using Bull Ring's custom router bits – they make the installation quick, easy, and create a perfect cut every time.
• 
  
• 
  For installation Bull Ring offers a custom router bit that enables you to quickly and easily trim out the top plastic rail to perfectly match the steel pocket underneath. Drill a ½” pilot hole in the center of the scribe lines, then insert our bit into a router, and set at 13/16” depth. The design of our router bit incorporates 4 roller bearings that run along the steel pocket as a guide. It only cuts the plastic, without scratching or cutting the painted metal surface of the rail. Using this router bit gives you a perfect cut every time, and allows you to then place our Retractable Anchor into the now exposed stake pocket for a perfect fit. Alternatively, you can use a razor blade to cut the plastic rail. The scribe lines that show the stake pockets on the rail caps are correct. So carefully use that blade to cut out the plastic square along those scribe lines, remove the plastic piece, and install our retractable anchor.
• 
  
  *Does not fit on 2020+ Tundra. Bed designs have changed on the 2020 model, where some trucks no longer have stake pockets underneath the plastic rail cap.

WARNING: Cancer and Reproductive Harm -  www.P65Warnings.ca.gov .  PRODUCT WARNING/LIABILITY DISCLAIMER:  Aftermarket accessories are intended to modify and/or prepare a vehicle for uses which exceed conditions anticipated by the vehicle manufacturer. These uses include high performance demands and negotiation of rough terrain. These conditions have extreme variance and cannot be controlled by the vehicle manufacturer or aftermarket accessory manufacturer. Therefore, the safe control of your vehicle is entirely your responsibility. Do not purchase parts unless you are willing to accept this responsibility. Do not install any part that you do not feel competent at installing without causing present or future injury to yourself or others; consult a professional installer.  Modification of your vehicle to enhance performance can result is dangerous situations that may result in bodily harm. The buyer hereby assumes all risks associated with any such modifications. The seller will not accept responsibility for personal injury or property damage arising from the failure of any parts.